Name of Symposia: S08 - Process Modeling and Simulation |
S08-5 Keynote
|
Extrudate Swell of HDPE Melts in Axisymmetric and Planar Flows Evan Mitsoulis, Vinod Kumar Konaganti, Savvas G. Hatzikiriakos
|
Not avalaible |
S08-365 Oral
|
Modeling of Micro Magnetic Particle Orientation for Powder Injection Molding Tae Gon Kang, Im Doo Jung, Seong Jin Park
|
Not avalaible |
S08-273 Oral
|
Influence of morphology on the mechanical properties of polymer nanocomposites filled with uniform or patchy nanoparticles Lu Wang, Jun Liu, Liqun Zhang, Alexey V. Lyulin
|
S08-267 Oral
|
Numerical simulations for injection moulding of postconsumer waste Frederik Desplentere, Sofie Deceur
|
S08-215 Oral
|
Tuning the mechanical properties of polymer nanocomposites filled with grafted nanoparticles by varying the grafted chain length and flexibility ZIXUAN WANG
|
S08-211 Oral
|
Polyarylene ether nitrile (PEN) based composites with enhanced crystalline, mechanical, dielectric properties by monoaxial hot-stretching Xiaobo Liu, Yong You
|
Not avalaible |
S08-188 Oral
|
Concept of Fatigue Design Methodology for short fibre reinforced Polymers considering fibre orientation and weld lines Andreas Primetzhofer, Andreas Moesenbacher, Gerald Pinter
|
S08-161 Oral
|
Numerical investigation on flow induced stress and molecular orientation for the non-isothermal viscoelastic filling flow in rapid heat cycle molding process Jitao Liu, Shuxiang Zhang
|
Not avalaible |
S08-115 Poster
|
Numerical simulation of flow and temperature during rotation extrusion Lin Pi, Min Nie, Qi Wang
|
Not avalaible |